Brocade Fabric OS Command Reference (Supporting Fabric OS v7.3.0) - Manual (Page 824)

794 Fabric OS Command Reference
53-1003131-01
portCfgShow
2
Displays supported on the Brocade 7800, Brocade 7840, and FX8-24 platforms
When issued on the Brocade 7800, Brocade 7840, and FX8-24, tunnels and parameters not applicable
to these platforms are not displayed. Use the portShow command to display FCIP tunnel and circuit
parameters on the Brocade 7800/FX8-24.
ipif
Displays the IP interface configurations. IPv6 addresses are supported.
arp
Displays the address resolution protocol (ARP) table. This option is supported on
Brocade 7800 and FX8-24 platforms.
iproute
Displays the IP route on the specified GbE port. IPv6 addresses are supported.
vlantag
Displays the VLAN tagging configuration. For each entry, the output displays the
IP interface address, the destination IP address, the VLAN ID, and the L2 CoS
priority. This display includes permanent entries only. Permanent entries are
configured at the IP interface level with the portCfg vlantag command. To view
VLAN tagged tunnels and circuits along with permanent entries, use the
portShow vlantag command. This option is suported on Brocade 7800 and
FX8-24 platforms
mgmtif ge_port
Displays the inband management interfaces configured for a specified GbE Port.
The display includes the interface status (enabled or disabled), the interface IPv4
Address, the netmask, effective MTU, and annotated port flags. This option is
supported on Brocade 7800 and FX8-24 platforms
mgmtroute ge_port
Displays the management routes configured for a specified GbE Port. The display
includes the destination IPv4 Address, the netmask, the gateway address, and
annotated port flags. This option is supported on Brocade 7800 and FX8-24
platforms
fcipcircuit
Displays FCIP circuits and related parameters.
fciptunnel
Displays FCIP tunnels and related parameters.
The following options are supported with fcipcircuit and fciptunnel:
all
Displays information for all FCIP tunnels.
ve_port
Displays information for the specified FCIP tunnel. To display the tunnel, specify
the VE_Port number associated with the tunnel configured on one of the GbE
ports. VE_Ports are numbered 16-23.
optional_argument
The following optional argument is supported with fciptunnel:
-ipsec
Displays whether IPSec is enabled or disabled. If enabled, the key is
displayed. If IPSec is enabled and configured in legacy mode, the mode is
displayed as "legacy". The mode information is displayed whether or not you
issue the -ipsec option.
ipsec-policy
Displays the IPsec policy. This option is supported on the Brocade 7840 switch
only.