Brocade Fabric OS Command Reference (Supporting Fabric OS v7.3.0) - Manual (Page 976)

946 Fabric OS Command Reference
53-1003131-01
portStatsShow
2
ge_err_overrun
The number of overruns observed on the GbE port.
ge_err_fifo_ovf
The number of times an overflow of the first in first out (FIFO) queue was
observed on the GbE port.
ip_err_hdr_cksum
The number of checksum errors observed on the GbE port.
ip_err_tcp_data_chksum
The number of IP TCP data checksum errors observed on the GbE port.
NOTES
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
This command is not supported on FCoE ports.
OPERANDS
This command has the following operands:
slot
For bladed systems only, specifies the slot number of the port to be displayed,
followed by a slash (/).
[ge]port
Displays statistics for a single port identified by the port number, relative to its slot
on bladed systems. Specify the optional ge option to display the GbE port
hardware statistics. Port ranges are not supported with this command. Use
switchShow for a listing of valid ports.
-i index1[-index2]
Displays statistics for a single port or for a range of ports identified by port index
numbers. You may specify multiple index ranges separated by a space, for
example, -i 33-47 65-73.
-f
Ignores nonexisting ports. This operand is valid only with the -i option.
-x [hex1 [-hex2]]
Specifies a port or a range of ports identified by port index numbers in
hexadecimal format. You may specify multiple port ranges separated by a space,
for example, -x 21-26 28-3c.
-slot [slot1[-slot2]
Displays statistics for all ports on a slot or on a range of slots, for example, -s 3-5.
You may specify multiple slot ranges separated by a space, for example, -s 3-5
8-10.
ge
Displays the GbE port statistics.
ip
Displays all GbE port statistics related to IP addresses that are not zero. This
operand is not supported on the Brocade 7800 and FX8-24 platforms.
ip_address
Specifies an IP address to display statistics only for the specified IP address. This
operand is optional and valid only with the ip option.
fcip
Displays the GbE statistics on all FCIP tunnels. This operand is not supported on
the Brocade 7800 and FX8-24 platforms.