LumaSense Technologies INNOVA 1314i - Manual (Page 116)

Chapter 10
______________________________________________________________________
_____________________________________________________________________________
BE6030-13 1314i Photoacoustic Gas Monitor LumaSense Technologies A/S
Page 116 of 199
4. Locate the input port on the printer.
5. Push the connector at the other end of the cable on to this socket,
and secure it firmly using the securing screws.
The instruments can be turned on at the mains now.
10.3 Setting-up Communication Parameters
WARNING!: You must perform a PARTIAL RESET of the Monitor
(press the RESET and S1 buttons) if the active value of any
parameter in this branch of the Set-Up Tree is changed. If the
Monitor is not partially reset, then, the Monitor will not up-date the
communication-parameter data which was used last time data was
transmitted via either of its interfaces. By performing a partial reset
you ensure that the Monitor has the parameters necessary to enable
it to transmit data to the attached printer.
Press SET-UP S3 S1 S3 and the following text is displayed:
SELECT COMMUNICATION SET-UP BRANCH
RS 232 C ADDRESSABLE CONNECTIONS
If you are using the RS-232 interface, go to section 10.3.1 .
10.3.1 RS-232 Interface
A brief description of the communication parameters is given below.
A list of the parameters, together with the values available and their
factory default values are shown in Table 10.1 .
The parameters in this branch decide how the Monitor communicates
via the RS232 interface.
SELECT BAUD RATE gives the rate at which data should be
transmitted from the Monitor via its RS-232 interface.
SELECT NUMBER OF STOP BITS gives the number of stop bits,
which should be used when data is transmitted from the Monitor to
other equipment.
SELECT NUMBER OF DATA BITS gives the number of data bits,
which should be used when data is transmitted between the Monitor
and other equipment.