LumaSense Technologies INNOVA 1314i - Manual (Page 42)

Chapter 4
______________________________________________________________________
_____________________________________________________________________________
BE6030-13 1314i Photoacoustic Gas Monitor LumaSense Technologies A/S
Page 42 of 199
Stand-alone Settings
Monitoring Task Set-up Number = 1
Sampling = Continuous
Monitor for preset period = No
Compensate for Water Vapour
Interference = Yes
Compensate for cross-interference =
No
Measure Gas A: XXXXXX = Yes
Measure Gas B: XXXXXX = No
Measure Water Vapour = Yes
Note: flushing is set in Environmental
Parameters, section 4.3.3 , and the
S.I.T’s are set up in the Filters setup,
section 12.3.3
1. Press SET-UP, S1 and then S1.
This brings you into the Monitoring Task branch of the Set-Up Tree
where the following text is displayed:
Up to 10 different monitoring tasks can be set-up while operating the
Monitor in Set-up mode. The parameters describing these tasks are
automatically stored in the memory of the Monitor.
2. If the number on the display is already “1” then press q to
“accept” the value.
If the number is not “1”:
a.
Press ¿ and use the direction keys to change its value to “1”.
b.
Press ¿ to accept the value.
MONITORING TASK SET-UP NUMBER 1
PRESS ENTER TO CHANGE VALUE