LumaSense Technologies INNOVA 1314i - Manual (Page 55)

Chapter 4
______________________________________________________________________
_____________________________________________________________________________
BE6030-13 1314i Photoacoustic Gas Monitor LumaSense Technologies A/S
Page 55 of 199
4. Press SET-UP.
Use q to scroll through the results of the monitoring task no. 1
displayed on the screen. Notice that the water vapour unit has been
changed to ppm.
4.3.12 Changing the Pressure Unit after a Monitoring Task
1. Press SET-UP S3 S2 and then q to reach the following
display:
2. Press S3 to accept the unit of mmHg.
3. Press SET-UP.
Use q to scroll through the results of the monitoring task no. 1
displayed on the screen. Notice that the Pressure unit has been
changed to mmHg.
SELECT PRESSURE UNIT
kPa mBar mmHg