LumaSense Technologies INNOVA 1314i - Manual (Page 88)

Chapter 7
______________________________________________________________________
_____________________________________________________________________________
BE6030-13 1314i Photoacoustic Gas Monitor LumaSense Technologies A/S
Page 88 of 199
Immediate Start
If you selected an immediate start, the following text appears on
the screen:
MEASUREMENT IN PROGRESS
RESULTS NOT YET AVAILABLE
2. When the first measurement cycle is complete the Monitor will
automatically display the results and update them every time a
new measurement cycle is completed. An example is shown
below:
This display gives the overview of the gas/vapour concentrations last
measured – in this case the concentration of gas A and humidity of
the water vapour are in the units that were selected – that is mg/m 3
for gas A and Tdew for water vapour (see section 4.3.2 ).
If no pre-set monitoring period is defined, then to stop the
monitoring task, press MEASURE and S3.
A : 4.52 E + 01 B :__________ C : _________
D : __________ E : __________ W : 8.33 E + 00