LumaSense Technologies INNOVA 1314i - Manual (Page 123)

Chapter 10
______________________________________________________________________
_____________________________________________________________________________
BE6030-13 1314i Photoacoustic Gas Monitor LumaSense Technologies A/S
Page 123 of 199
10.7 Printing-out Data from the Monitor
Before data can be printed out from the Monitor, the communication
parameters must be checked/changed. This is explained in section
10.3.1 for RS-232 communication and in section 10.3.2 for the
Ethernet communication. The text line terminator must be set (see
section 10.4 ) before printing can proceed.
Setting the Data Logging function is described in section 10.5 .
10.7.1 Starting a Print-out
Press PRINT and then one of select push-buttons S1 S2 or S3
depending on which data block you wish to print-out.
10.7.2 Stopping a Print-out which is in Progress
If a print-out is in progress and you wish to stop it, then the
following steps need to be followed:
1. Press the PRINT button on the Monitor’s front panel.
The following text will appear on the display:
PRINT ABORTING
PLEASE WAIT
The printer will stop printing data.
2. Use the Line Feed function on the printer if the paper is not
ejected automatically.