SkyTrak 8042 Service Manual - Manual (Page 132)

3.71 Model 8042, 10042, 10054 Legacy Rev. 03/04
Boom
Note: If replacing the inner boom assembly with a new
inner boom, the quick attach assembly and the
Attachment Tilt cylinder should be removed at this time.
If the inner boom is not to be replaced, the quick attach
assembly and Attachment Tilt cylinder can remain in
place. Proceed to Step 42.
33. Remove the elastic locknut (13) and capscrew (14)
holding the Attachment Tilt cylinder rod end pin (15)
to the quick attach assembly (16). Save the
capscrew and discard the elastic locknut.
34. Support the rod end of the Attachment Tilt
cylinder (17). Use a brass punch and rawhide
hammer to remove the rod end pin (15) from the
quick attach assembly.
35. Inspect the pin (15) for nicks or surface corrosion.
Use fine emery cloth to repair minor nicks or
corrosion. If damaged or if it cannot be repaired, the
pin must be replaced.
36. Remove the elastic locknut (18) and capscrew (19)
holding the quick attach pivot pin (20) to the quick
attach assembly (21). Save the capscrew and
discard the elastic locknut. Place a support under
the quick attach assembly to prevent it from dropping
when the pivot pin is removed.
37. Use a brass punch and rawhide hammer to remove
the quick attach pivot pin (20) from the quick attach
assembly and the bushings in the gooseneck.
Record the location and quantity of the shim
washers (22 and 23) as the pin is being removed.
Save the washers (22 and 23) from each side of the
quick attach.
38. Inspect the pivot pin (20) for nicks or surface
corrosion. Use fine emery cloth to repair minor nicks
or corrosion. If damaged and if it cannot be repaired,
the pin must be replaced.
MH0940
~
13
14
15
16
17
MH0950
22
23
~
18
19
20
21
22
23