SkyTrak 8042 Service Manual - Manual (Page 408)

7B.41 Model 8042, 10042, 10054 Legacy Rev. 10/03
Engine: Cummins QSB4.5T
20. Insert the fork terminal of the blue wire (8) into the
protective cover (9) on the starter solenoid terminal.
Use a small phillips screwdriver to tighten the
screw (10) securely.
21. Snap the tethered cap back in place over the screw
in the protective cover.
22. On the engine block, connect the engine ground buss
bar (15) with the wires (16) still attached to the bar.
23. At the negative starter stud (13), connect the
negative (-) battery cable (14).
24. At the positive starter stud (9), connect the positive
(+) battery cable (10) and starter positive buss
bar (11) with the wires (12) still attached to the bar.
25. Label and disconnect the alternator wires:
• AG1 and AG2 from G terminal (6)
• AB1 and AB2 from B terminal (7)
• 38 and 6 from D terminal (8)
26. Install the exhaust system to the engine. Refer to
Section 7B.9.2, “Exhaust System Installation.”
27. Install the air cleaner assembly on the engine. Refer
to Section 7B.10.2, “Air Cleaner Assembly
Installation.”
28. Install the radiator and oil cooler. Refer to Section
7B.6.4, “Radiator/Hydraulic and Transmission Cooler
Replacement.”
29. Install the rear engine access door with the help of at
least one assistant. Refer to Section 4.7.1, “Access
Panel and Cover Replacement.”
MU6190
8
10
9
MH5660
13
14
9
10
11
12
15
16
MH5670
6 7 8