SkyTrak 8042 Service Manual - Manual (Page 254)

4.15 Model 8042, 10042, 10054 Legacy Rev. 10/03
Cab and Covers
9. Remove four button-head capscrews (14) and
remove the console panel (15).
10. Remove four button-head capscrews (16) and
remove the joystick panel assembly (17) from the
vehicle.
Joystick Assembly Installation
1. Route the control cables through the opening, the
console, and through the opening at the bottom of
the cab. Secure the joystick panel assembly (17)
with four button-head capscrews (16).
2. Route the control cables through the opening at the
bottom of the frame.
3. Connect the frame attachment tilt control cable to
the main control valve assembly:
a. Install the cable in the bracket, and slide the jam
nut (12) over the end of the attachment tilt control
cable (10). DO NOT tighten the jam nuts at this
time.
b. Connect the end of the cable to the shaft from
the control valve. Secure with an anchor pin and
spring pin (11).
c. Adjust the jam nuts until the distance (9) from the
inner jam to the end of the ferrule is the same as
recorded during removal. Tighten the jam nuts.
4. Repeat Step 3 to install the frame sway control cable
(13).
MA8490
9
10
11
12
13
OH2430
~
14
15
14
MA8630
~
16
17
16