SkyTrak 8042 Service Manual - Manual (Page 173)

Boom
3.112 Model 8042, 10042, 10054 Legacy Rev. 03/04
16. Loosen the wear pad mounting bolts (1) holding the
hose guide (2) and wear pads (3) to the side of the
inner boom. Remove the wear pad mounting bolts
(one at a time) with washers.
17. Apply Loctite
®
242 threadlocker to the threads of the
hose guide and wear pad mounting bolt (1). Reinsert
the bolts with washers, but DO NOT fully tighten.
Swing the back of the hose guide down to line up the
rear notches with the holes in each side of the inner
boom.
Note: ALWAYS replace elastic locknuts with new elastic
locknuts to help ensure proper fastening.
18. Insert a capscrew (4), saved, through the hole in the
inner boom. Secure the hose guide in place with a
flat washer (5), saved, and a new elastic locknut (6).
19. Torque all wear pad/hose guide mounting capscrews
to 31 ±3 lb-ft (42 ±4 Nm).
20. Run the hose carrier out and in by hand to check for
interference.
IMPORTANT: DO NOT allow the Attachment Tilt and
auxiliary hydraulic hoses to cross inside the inner boom.
21. At the front of the inner boom, pull the two hoses that
were labeled “Attachment Tilt - Retract” (7) left side
and “Attachment Tilt - Extend” (8) right side out the
opening in the back of the gooseneck. Let the hoses
hang out the back of the gooseneck.
22. At the front of the inner boom, pull the two hoses that
were labeled “Auxiliary - Female Coupler” (9) left
side and “Auxiliary - Male Nipple” (10) right side out
the opening in the gooseneck and down to the
bulkhead plate, where the auxiliary hydraulic
couplers are to be mounted. Let the hoses hang
inside the gooseneck.
MH2480
1
2
3
4
5 6
MH2490
7
8
9
10