Hydraulic system – SkyTrak 8042 Service Manual User Manual

Page 470

Advertising
background image

8.55

Model 8042, 10042, 10054 Legacy

Rev. 10/03

Hydraulic System

Not

OK

Not

OK

If there is no four-wheel or crab

steering, check the steer select valve.

Inspect/replace the steer select valve.

Check the steer select switch and wiring.

Refer to the steering circuits and

components in Section 9.7, “Electrical
System Troubleshooting,” and Sec
tion

9.14, “Switches and Solenoids.”

If OK

Not

OK

Not

OK

Not

OK

If there is no steering, check the

steering system electrical components.

If OK

Not

OK

Front or rear wheels are not parallel

in front or four-wheel steering mode.

Perform indexing procedure on vehicle.

Check wheel alignment.

Not

OK

Check the steer select valve.

Replace the steer select valve.

If OK

Refer to the steering circuits and

components in Section 9.7, “Electrical
System Troubleshooting,” and Sec
tion

9.14, “Switches and Solenoids.”

Check the pressure at the “PSG” port of the

secondary function manifold.

Refer to Section 5.3.8, “ZF Axle Repair

Manuals,” for proper ZF Axle Repair

Manual for further information.

Not

OK

Check packing in steering cylinders.

If OK

Repair/replace steering cylinder(s).

If OK

If OK

Not

OK

Not

OK

Not

OK

Not

OK

Not

OK

Check the front and rear steering cylinders

for packing leaks.

Repair/replace steering cylinder(s).

If OK

Check pump flow.

If OK

Not

OK

Check the power steering unit.

Replace power steering unit.

If OK

Check the main system pressure on the

main control valve.

Adjust/replace the relief valve.

Check the pump compensator pressure.

Consult factory to adjust the

compensator pressure at the pump.

Check the shuttle valve.

Replace shuttle valve.

If OK

If OK

Repair/replace pump.

If OK

If OK

Not

OK

Check the load sense pressure at the “PLT”

port on the secondary function manifold.

Adjust/repair/replace the pressure reducing

valve on secondary function manifold.

Not

OK

Check that the check valve fitting at the

power steering unit is operating properly.

Replace check valve fitting.

If OK

Adjust/repair/replace the pressure reducing

valve on secondary function manifold.

Advertising
This manual is related to the following products: