SkyTrak 8042 Service Manual User Manual
Page 838
9.247
Model 8042, 10042, 10054 Legacy
Rev. 10/03
Electrical System
b. Boom Angle Sensor Installation
1. Install boom angle sensor (2) through outside of
boom frame.
2. Install inside locknut (6) onto sensor.
3. Measure the clearance between the sensor and
frame, and adjust sensor distance (7) to .120"
(3,05 mm) and tighten locknut (6).
4. If the vehicle has one battery, connect the
negative (-) battery cable to the negative (-) battery
terminal (4).
If the vehicle has dual batteries, connect both
negative battery cables to both negative (-) battery
terminals (5).
9.14.18
Boom Extend Interlock Sensor
Removal/Replacement (10054 Only)
The boom extend interlock sensor (8) is located on the
left side of the vehicle, on the outer boom frame (9) and
just behind the cab. The boom extend interlock sensor
prohibits the last boom section from extending unless
both outriggers are down and pressure is applied to the
ground surface.
a. Boom Extend Interlock Sensor Removal
1. If the vehicle has one battery, disconnect the
negative (-) battery cable at the negative (-) battery
terminal (4).
If the vehicle has dual batteries, disconnect both
negative battery cables from both negative (-) battery
terminals (5).
2. Make note of wire tie locations and clip wire ties
where necessary.
3. Disconnect boom extend interlock sensor (8)
electrical connector (10) from the boom extend
harness connector (11).
4. Loosen the inside locknut (12) on the sensor.
5. Slide the sensor out of the bracket (13) and remove
from vehicle.
b. Boom Extend Interlock Sensor Installation
1. Partially install inside locknut (12) onto the sensor.
2. Make sure that there are four to six threads,
approximately .75" and 1.00" (14), between the
outside locknut (15) and the end of the sensor (8).
3. Make sure that the wire harness (16) is between the
bracket (13) and the sensor (8), and slide the sensor
into the bracket (13).
4. Connect the boom extend interlock sensor
connector (10) to the boom extend harness
connector (11).
5. Replace wire ties as necessary.
6. If the vehicle has one battery, connect the
negative (-) battery cable to the negative (-) battery
terminal (4).
If the vehicle has dual batteries, connect both
negative battery cables to both negative (-) battery
terminals (5).
MH6120
8
9
10
11
12
13
14
15
16