SkyTrak 8042 Service Manual - Manual (Page 257)

Cab and Covers
4.18 Model 8042, 10042, 10054 Legacy Rev. 10/03
8. Remove three capscrews (1), three lockwashers and
three flat washers.
9. Remove the auxiliary hydraulic joystick assembly (2)
from the vehicle.
b. Auxiliary Hydraulic Joystick Installation
1. Route the control cable through the opening at the
bottom of the cab.
2. Secure the auxiliary hydraulic joystick assembly (2)
to the cab console with three capscrews (1), three
lockwashers and three flat washers.
3. Connect the auxiliary hydraulic control cable to the
main control valve:
a. Slide the inner jam nut (3) over the end of the
auxiliary hydraulic control cable (4), and install
the cable in the bracket with one nut on either
side of the bracket. DO NOT tighten the jam nuts
at this time.
b. Connect the end of the cable to the shaft from
the control valve. Secure with an anchor pin and
spring pin (5).
c. Adjust the jam nuts until the distance (6) from the
outer jam nut to the end of the ferrule is the same
as recorded during removal. Tighten the jam
nuts.
4. Install the console panel (7) and secure using four
button-head capscrews (8).
MA8530 1
2
MA8490
~
3
4
5
6
OH2430
~
7
8
8