SkyTrak 8042 Service Manual - Manual (Page 611)

Electrical System
9.20 Model 8042, 10042, 10054 Legacy Rev. 10/03
9.6.3 Fuse and Relay Replacement
Shut off the engine and disconnect the negative (-) battery
cable(s) at the negative (-) battery terminal(s) before
checking the electrical system fuses or relays.
1. Unlock and open the rear engine door.
2. If the vehicle has one battery, disconnect the
negative (-) battery cable at the negative (-) battery
terminal (1).
If the vehicle has dual batteries, disconnect both
negative battery cables from both negative (-) battery
terminals (2).
a. Fuse Block Fuse or Relay Replacement
Remove a suspect fuse (3) or relay (4) (Refer to Section
9.6.2, “Fuse and Relay Locations,” for locations of fuses
and relays) from the fuse and relay panel by pulling the
fuse or relay straight out and away. ALWAYS install the
correct amp rated fuse or relay.
b. Engine Compartment Fuse Replacement
(SN 8042, 18991 - 19987, 10042 19031 - 19987,
10054, 19080 - 19987 And
8042/10042/10054, 0160002332 & After)
Cold Start Grid Heater Fuses
1. To access the fuses (5) open the protective
covers (6) from the engine panel side. Allow the
covers to rotate on the tethers on the engine side of
the holder (7).
2. Remove the two hex nuts (8) and lockwashers (9)
securing the fuse (5) and wires to the fuse
holder (7). Remove the fuse and replace with a new
fuse.
3. Place the new fuse and then the wires onto the studs
of the holder. Secure the fuse and wires in place with
the lockwashers (9) and hex nuts (8). Torque the hex
nuts to 7-9 lb-ft (10-12 Nm).
4. Snap the protective cover (6) back in place. Be sure
the cover snaps securely in place on the holder.
WARNING:
DO NOT perform service or
maintenance on the vehicle with the engine
running, with the exception of the transmission
level check. Contact with moving parts can
cause death or serious personal injury.
MH4890
1
2
MH4880
3
4
MH4900
9
6
7
8 9
5