SkyTrak 8042 Service Manual - Manual (Page 359)

Engine: Cummins 4BT3.9 and 4BTA3.9
7A.36 Model 8042, 10042, 10054 Legacy Rev. 10/03
22. Install the exhaust system to the engine. Refer to
Section 7A.9.2, “Exhaust System Installation.”
23. Install the radiator and oil cooler. Refer to Section
7A.6.3, “Radiator/Oil Cooler and Coolant Heater
Replacement.”
24. Install the back-up alarm (1) and fasteners onto
frame studs.
25. Connect the back-up alarm harness connector (2) to
the back-up alarm (1).
26. Install the engine exhaust. Refer to Section 7A.9.2,
“Exhaust System Installation.”
27. Install the rear engine access door with the help of at
least one assistant. Refer to Section 4.4.6, “Door
and Latches.”
28. Install the battery (3), hold-down bracket (4), two
threaded hold-down rods (5) and hold-down nuts (6).
29. Connect the positive (+) and negative (-) battery
cables (7 and 8).
30. Check that all hydraulic system, electrical system,
cooling system, fuel system, and exhaust system
connections are correct and connected tightly.
31. From within the cab, lightly depress the throttle pedal
(9) to full-throttle position. As needed, adjust the
limit-stop screw (10) until it touches the pedal. Tighten
the locknut (11) to 120-125 lb-in (13,6-14,1 Nm).
MH4030
1
2
MH4010
3 4
5
6
7 8
MA01912
9
10
11