SkyTrak 8042 Service Manual - Manual (Page 52)

2.27 Model 8042, 10042, 10054 Legacy Rev. 10/03
General Information and Specifications
2.5.12 Miscellaneous Specifications (All Models)
2.5.13 Tamper Proofing
A tamper-proof means is in place on the following
adjustable components prior to machine shipment. This
can either be tamper-proof paint or a steel tamper-proof
cap. DO NOT attempt to defeat, bypass or alter any
tamper-proof device.
• Main Valve Port Relief Valves (5) Standard, or (7)
Auxiliary Hydraulics
• Steering Relief Valve (1)
• Attachment Tilt Cylinder Counterbalance Valve (1)
• Lift/Lower Cylinder Counterbalance Valves (2)
• Extend/Retract Cylinder Counterbalance Valve (1)
• Main System Relief Valve (1)
• Parking Brake Relief (1)
• Pump Pressure Compensating Valve (1)
2.5.14 Fork Ratings
All approved forks for this vehicle are marked with a
maximum load capacity rating. This rating is stamped on
the left edge of the fork (1), just below the fork pivot shaft
(2). The rating is listed in U.S. pounds and based on a 24"
(610 mm) load center (3).
This rating specifies the maximum load capacity that the
individual fork can safely carry at a maximum load center
of 24" (610 mm).
Since forks are always used in multiples, the total rating
of any combination of forks is the sum of their rated
capacities.
Other than block forks, use all forks in matched pairs. Use
block forks in matched sets.
Steering Wheel:
Maximum Number of Turns, Lock to Lock 3.75 turns
Minimum Number of Turns, Lock to Lock 3.00 turns
Breakout Force:
Utility bucket (calculated at -24° lip angle, max. moment) 24,500 lb (11.113 kg)
XXXX - 24
XXXX - 24
OU0131
1
2
3