SkyTrak 8042 Service Manual - Manual (Page 243)

Cab and Covers
4.4 Model 8042, 10042, 10054 Legacy Rev. 10/03
4.3 OPEN CAB COMPONENTS
4.3.1 Seat/Seat Belt
a. Seat Removal
1. Park the vehicle on a firm, level surface. Level the
vehicle, ground the attachment, place the travel
select lever in the (N) NEUTRAL position, place the
neutral lock lever in the (N) NEUTRAL LOCK
position, engage the parking brake switch and shut
the engine OFF.
2. Place an Accident Prevention Tag on both the
ignition key switch and steering wheel, stating that
the vehicle should not be operated. (Refer to Section
1.5, “Accident Prevention Tags.”)
3. Disconnect the battery negative (-) ground cable or
cables (1) at the battery negative (-) terminal.
4. Remove the two capscrews (2), two lockwashers (3),
two flat washers (4) and two spacers (5) securing the
tethers (right-6 and left-7) to the seat riser.
5. Remove the four elastic locknuts (8) and four flat
washers (9) securing the seat (10) to the seat riser
(11).
6. Carefully remove the seat (10) from the cab.
7. If the seat is to be replaced: Remove the two
capscrews (12 and 13), two washers (14), seat belt
assembly (15), two spacers (16) and two flanged hex
nuts (17). Transfer these parts and two tethers (6-
right and 7-left) to the replacement seat with the
seat out of the cab.
b. Seat Installation
Note: ALWAYS replace elastic-lined nuts with new
elastic-lined nuts to help ensure proper fastening.
1. Position the seat (10) on the seat riser (11). Align the
studs on the seat with the mounting holes in the seat
riser. Secure the seat to the riser with four flat
washers (9) and four new elastic locknuts (8). Torque
nuts to 20 lb-ft (27 Nm).
2. Anchor the tethers (right-6 and left-7) to the seat
riser (11) using two spacers (5), two flat washers (4),
two lockwashers (3) and two capscrews (2).
MH4510
1
1
MA8750
2 3 4
5 6
7
8
9
10
11
3
12
13
14
15
16
17
5
14 15
4
17
16
2