SkyTrak 8042 Service Manual - Manual (Page 251)

Cab and Covers
4.12 Model 8042, 10042, 10054 Legacy Rev. 10/03
8042 S/N 18991 and After
10042 S/N 19031 and After
10054 S/N 19080 and After
a. Throttle Pedal Removal
1. Park the vehicle on a firm, level surface. Level the
vehicle, ground the attachment, place the travel
select lever in the (N) NEUTRAL position, place the
neutral lock lever in the (N) NEUTRAL LOCK
position, engage the parking brake switch and shut
the engine OFF.
2. Place an Accident Prevention Tag on both the
ignition key switch and steering wheel, stating that
the vehicle should not be operated. (Refer to Section
1.5, “Accident Prevention Tags.”)
3. Disconnect the battery negative (-) cables at the
battery negative (-) terminals.
4. Disconnect the wire harness plug (1) from the front
side of the throttle pedal (2).
5. Remove the capscrews (3), lockwashers (4) and flat
washers (5) holding the throttle pedal (2) to the cab
floor. Save all hardware for reassembly.
6. Remove the throttle pedal from the cab.
b. Throttle Pedal Installation
1. Position the throttle pedal in the cab. Line up the
mounting holes in the throttle pedal with the
mounting holes in the cab floor.
2. Secure the throttle pedal (2) in place with the flat
washers (5), lockwashers (4) and capscrews (3).
Tighten securely.
3. Reconnect the wire harness plug (1) to the front of
the throttle pedal (2). Snap the plug securely in
place.
4. Connect the battery negative (-) cables to the battery
negative (-) terminals.
MH4280
1
2
3
4
5