SkyTrak 8042 Service Manual - Manual (Page 67)

Boom
3.6 Model 8042, 10042, 10054 Legacy Rev. 03/04
9. If your vehicle is equipped with optional auxiliary
hydraulics, label and remove the two hoses (1) from the
bulkhead fittings (2) inside the gooseneck (3). Plug
the hose ends and cap the bulkhead fittings to
prevent dirt and debris from entering the hydraulic
system.
If you are replacing the inner boom with a new inner
boom: Remove the female coupler, male nipple and
bulkhead fittings from the bulkhead plate inside the
gooseneck.
10. Remove the thumbscrew (4), lockwasher (5) and flat
washer (6) holding the rear cover (7) to the rear of
the outer boom (8). Lift the rear cover straight up
until the capscrew in the top of the cover clears the
retaining hole in the top of the outer boom. Remove
the cover from the outer boom.
11. With auxiliary hydraulics: Inside the inner boom,
loosen but DO NOT remove the two capscrews (9)
securing the left side wear pad and hose clamp
support bracket (10) to the top of the inner boom.
12. Remove the two capscrews (11), two
lockwashers (12) and two flat washers (13) holding
the stack clamps (14) and hose clamp support
bracket (10) to the left side of the inner boom.
Remove the clamps and the clamp support bracket
from the inner boom.
MH0840
1 2
3
2
MH0850
4
5
6
7
8
MH2840
9
10
11
12
13
14
10