SkyTrak 8042 Service Manual - Manual (Page 357)

Engine: Cummins 4BT3.9 and 4BTA3.9
7A.34 Model 8042, 10042, 10054 Legacy Rev. 10/03
9. Secure the throttle cable clevis (1) to the engine
throttle lever (2), located just above the starter.
10. Install the throttle cable mount clamp (3) over the
throttle cable (4).
11. Connect the fuel inlet line (5) to the fuel lift pump (6).
12. Connect the fuel return line (7) to the fuel injector
pump (8).
13. Raise the drive shaft assembly (9) into position. The
slip-yoke end of the drive shaft mounts toward the
engine. If reinstalling a drive shaft previously
removed, align the flange yokes according to the
alignment marks made during removal.
IMPORTANT: Yokes at both ends of the drive shaft must
be in the same plane to help prevent excessive vibration.
Note: If installing a new drive shaft unit, special attention
need not be applied to installation. New drive shaft units
are balanced at the factory.
14. At the drive shaft (9), install the capscrews (10) and
lockwashers (11), securing the flange yoke (12) to
the engine. Torque to 105 ±10 lb-ft (142 ±14 Nm).
Note: The engine harness is routed and attached at
various places on the engine using hold-down clamps
and plastic wire ties. Before installing engine and with
the help of an observer, ensure that engine clears the
harness during installation.
15. Connect the engine coolant temperature switch lead
(13) and oil pressure switch lead (14). Refer to
Section 9.14.12, “Engine Coolant High Temperature
Sender,” and Section 9.14.11, “Engine Low Oil
Pressure Sender.”
16. Connect the fuel shut-off solenoid harness
connector (15) to the fuel shut-off solenoid.
MT2530
1
2
3
4
5
6
7
8
MA8900
To Engine
To Transmission
9
10
11
12