SkyTrak 8042 Service Manual - Manual (Page 802)

9.211 Model 8042, 10042, 10054 Legacy Rev. 10/03
Electrical System
b. Normal Operating Lights
After the engine starts, the operator’s instrument
cluster (7) provides information via the following
indicators:
Fuel Level Indicator
The fuel level indicator (8) represents the
quantity of fuel remaining in the fuel tank. For
additional information, refer to Section 9.8.36,
“Fuel Level Indicator Troubleshooting.”
Hourmeter Indicator
The hourmeter indicator (9) displays the total
number of running hours of the vehicle. The
hourmeter only functions when the engine is
running.
c. Function Indicator Lights
There are three subdued or “hidden” function indicator
lights on the display panel that illuminate only when a
specific function is activated. They are:
Stabil-Trak™ Indicator
The Stabil-Trak™ indicator (10) illuminates with
the boom above 40° and the parking brake
engaged, travel select lever in (N) Neutral or the
service brake pedal depressed and held.
Park Brake Indicator
The park brake indicator (11) illuminates anytime
the park brake switch is applied, and the ignition
key switch is in the RUN position.
High-Beam Indicator (Optional)
The high-beam indicator (12) illuminates when
the optional headlight switch is placed in the
HIGH-BEAM position.
Directional Light Indicator (Optional)
The directional light (turn signal) indicator (13)
illuminates when the optional directional light
lever is moved either to the LEFT or RIGHT turn
position.
d. Operator’s Instrument Cluster Removal
1. If the vehicle has one battery, disconnect the
negative (-) battery cable at the negative (-) battery
terminal (3).
If the vehicle has dual batteries, disconnect both
negative battery cables from both negative (-) battery
terminals (4).
2. Remove the four fasteners (14) securing the right
side access panel (15).
3. Unscrew the locking ring from below the instrument
cluster (16). Pull the instrument cluster up and away
from the cut-out, and unplug the harness connector.
OH24703
0000 00
P
MH3970
7
8
9
10
11
12
13
OS02602
OH2500
P
OH24802
CAUTION:
Static electricity can cause
damage to the operator’s instrument cluster.
Avoid any manner of touching (hands, tools,
etc.) the printed circuit boards and terminals.
Disconnect the negative (-) battery cable at its
battery terminal (3 or 4) before beginning this
procedure. Failure to comply can result in
damage to the operator’s instrument cluster
and malfunction of the instruments and
indicator lights.
MA8260
MA8270
OH2430
14
15
16