SkyTrak 8042 Service Manual - Manual (Page 156)

3.95 Model 8042, 10042, 10054 Legacy Rev. 03/04
Boom
Note: ALWAYS replace elastic locknuts with new elastic
locknuts to help ensure proper fastening.
34. Assemble the tube clamp halves (21) to the
extend (22) and retract (23) tubes under the outer
boom. Place one clamp half on top of the tubes and
one on the underside of the tubes. Place a clamp
cover (24) on the top and bottom of the clamps.
Secure in place with the capscrew (25), saved, and a
new elastic locknut (26). Position the clamp halves to
securely hold the tubes without putting tension on
either tube. Tighten the elastic locknut securely.
35. Assemble the boom extend hose (27) to the inside
bulkhead fitting (extend tube) on the right side of the
boom. Remove all twists from the boom extend
hose, and tighten the hose end securely to the
bulkhead fitting.
36. Assemble the boom retract hose (28) to the outside
bulkhead fitting (retract tube) on the right side of the
boom. Remove all twists from the boom retract hose,
and tighten the hose end securely to the bulkhead
fitting.
IMPORTANT: DO NOT fully tighten the tube connections,
until all tubes are assembled at both ends.
37. Position the extend tube assembly (29) onto the
inner bulkhead fitting (30). Assemble the nut on the
tube assembly to the bulkhead fitting.
38. Position the retract tube assembly (31) onto the
second bulkhead fitting (32). Assemble the nut on
the tube assembly to the bulkhead fitting.
39. Position the inner (to male nipple) auxiliary tube
assembly (33) onto the third bulkhead fitting (34).
Assemble the nut on the tube assembly to the
bulkhead fitting.
40. Position the outer (to female coupler) tube
assembly (35) onto the outer bulkhead fitting (36).
Assemble the nut on the tube assembly to the
bulkhead fitting.
MH1160
14 18
14
15
16
17
18
19
20
MH1150
24
21
22
23
24
25
26
MH1140
27
28
MH1440
29
30
31
32
33
34
35
36