IPitomy IP1100+ PBX Administrator Guide - Manual (Page 149)

IPitomy IP PBX Admin Guide
2011 Copyright  IPitomy Communication, LLC 131 v4.0.1
www.ipitomy.com
Sections/Fields Description
Name
The name that is associated with the branch office. Both sites involved in the
Branch Office connection must use the same Name.
NOTE: This field will not allow spaces in the name. It must be all one word. Symbols
can be used (i.e. underscore “_” dashes “-”, etc.) can be used in place of spaces.
Host
Enter the static IP of the system your PBX is connecting to. If they do not have a
static IP address, enter the word dynamic.
Dial Prefix
The dial prefix must be an asterisk, plus two numbers (ie. *22). This prefix must be
dialed to reach any destination on another PBX that has not been entered as a
Branch Extension.
Password
This is the password that will allow access to the PBX. Both sites involved in the
Branch Office connection must use the same Password.
Register
YES= to require that the branch office register with the PBX system. Only used if
the Host is set to dynamic.
NO = does not require that the branch office register with the PBX system.
Enable Trunking
YES = Branched PBXs are able to dial calls out your PBXs trunks.
NO = Branched PBXs are not able to dial calls out your PBXs trunks.
Enable Multisite
Manager
Connection: Defines if Multi-Site Call Manager functionality is enabled. This feature requires a
license from IPitomy to be functional.
Qualify
The time in milliseconds that the PBX should check that the branch office is still
online. Setting this to zero may increase Branch Office stability.
Enable IAX2
Trunking
Indicates whether to use IAX trunking. If enabled (YES), this setting can help
eliminate packet overhead by cutting the cost of continuous communication.
Allow Codecs:
Defines what codecs this branch office can use for calls. Priority for codecs are
defined from top to bottom.
Class of Service:
Allows for individual Branch Offices to use different COS. Setting to None will
follow the default Branch Office COS defined under PBX Setup
General.
Table 49 – Branch Office Settings and Descriptions