IPitomy IP1100+ PBX Administrator Guide - Manual (Page 169)

IPitomy IP PBX Admin Guide
2011 Copyright  IPitomy Communication, LLC 151 v4.0.1
www.ipitomy.com
Start Pattern
Enter the start pattern of as the code your provider uses for information,
in this case “411”
Digits
Enter the length of the code your provider uses for information, in this
case “3”
Exact Length
Set the exact length to “YES”
Subroute Digits
Set the Subroute digits to “-1” (minus 1).
Subroute Offset
Set the Subroute offset to “0”
Trunks
Add any trunks that are appropriate for dialing Information with the code
created.
Table 55 – Information (411) Subroute Configuration
!
IMPORTANT: Please keep in mind that all new routes need
to be added to a Class of Service before the route can be
used. Subroutes are automatically added under the parent
route they use.
PBX Setup
PBX setup is used by a System Administrator to manage system-specific and system-wide settings. Typically
these pages will be visited once during installation, and then won’t be changed in the future.
General System Setup
While not visited often, the General settings page pertains to some core PBX components, like administrator
Username and Password, Time Settings, System Operator, Mailbox Exit Destination, Directory Type,
Autoprovisioning, and Security Settings.
Admin Settings Section
Figure 81 – PBX Admin Settings Section
Sections/Fields Description
Admin User Name
The administrator user name for the PBX system, default is pbxadmin
Admin Password
The administrator password for the PBX system, default is ipitomy. Once
installed, we recommend you change this to a strong password.