IPitomy IP1100+ PBX Administrator Guide - Manual (Page 56)

IPitomy IP PBX Admin Guide
2011 Copyright  IPitomy Communication, LLC 38 v4.0.1
www.ipitomy.com
(Detection) allows the line/channels to be more permissive of tone lengths and result in over
detecting. By default this is set to No.
!
IMPORTANT: We recommend that this parameter is set to
NO unless you are having issues. Please contact IPitomy’s
Technical Support Group for assistance or more
information.
DTMF Tone Duration
This allows you to set the DTMF tone duration in milliseconds (ms) for generated
tones generated by calls bridged to SIP devices. Default value of 300.
Use Inbound CoS
This allows you to enable/disable inbound routing and provides the dial plan that
corresponds to the outbound routes in this Class of Service (CoS). This is Off by
default.
!
IMPORTANT: Use this only if you intend to provide PSTN
connectivity to 3 rd party equipment. Please contact
IPitomy’s Technical Support Group for assistance or more
information.
Phone Numbers
On a T1 or PRI, this is where you would configure any DID information. Only
numbers or a + should be entered for a DID. Once configured, you can define a
different inbound destination for each number, allowing you to route calls to separate
places. Contact your provider to find out if they are sending 4, 7, or 10 digits inbound
for the DID.
Table 13 – Hardware Provider Configuration Settings and Descriptions
Add Phone Numbers to Hardware Provider
Once all the destinations are created, they will appear in a drop-down list and can be selected for updating.
STEPS:
If a DID destination is set to NONE, it will route to the default location for the trunk
itself.
1 From Channel Groups section of the Hardware Provider page, click the icon to the
right of the name you want to modify. The Edit Hardware Providers page appears.
2 The hardware trunks and their values that have already been provisioned will be
displayed. Scroll down the page to the Phone Numbers section. Enter the phone
number that you want to add then click the ADD button. You can also copy and paste a
list in. The list should be separated by newline characters.
3 The phone number entered will appear in the drop-down list to the right of the ADD
button. The numbers will be listed in sequential order.
4 Click on the button to save the changes to the system.
5 Click the Apply Changes link located on the right hand corner of the page, to commit the
changes to the database.