IPitomy IP1100+ PBX Administrator Guide - Manual (Page 177)

IPitomy IP PBX Admin Guide
2011 Copyright  IPitomy Communication, LLC 159 v4.0.1
www.ipitomy.com
Outbound Transfers Numbers Section
This setting allows outside numbers, such as cell phones or land lines, which receive calls through the PBX to
press ## to transfer the call. Once connected, the call can be transferred to someone else at the office or another
number, depending on configuration. Simply ask them to hold, then press ##. After a moment the PBX will say
“Transfer”, after which you can dial the number where the call should be transferred to. Any numbers listed here
will be able to perform this type of transfer.
Use the Transfer Permissions setting to define where calls may be transferred to. Internal Only restricts the
transfers to extensions only. If you set it to an extension, then you can transfer anywhere that extension could,
following the Class of Service for outbound dialing.
Figure 86 – Outbound Transfer Numbers Section
Add Outbound Transfers
STEPS:
1 From the PBX Setup General System Setup page, locate the Outbound Transfer
Numbers section.
2 To in the box to the left of the Add button, enter the phone number you wish to be able to
use this transfer feature. Click Add to move the number to the list. Repeat this step for all
the numbers you want to add.
3 Select the desired permission from the Transfer Permissions drop-down list.
4 Click the button to save the changes.
5 Click the Apply Changes link located at the top right hand corner of the page, to commit
the changes to the database.
Delete Outbound Transfers
STEPS:
1 From the PBX Setup General System Setup page, locate the Outbound Transfer
Numbers section.