IPitomy IP1100+ PBX Administrator Guide - Manual (Page 95)

IPitomy IP PBX Admin Guide
2011 Copyright  IPitomy Communication, LLC 77 v4.0.1
www.ipitomy.com
Table 27 – Advanced Filter Settings and Descriptions
Advanced Scan Settings
Changes to Scan Settings are kept when you click the GUI ‘Refresh’ button. Clicking on your browser’s
refresh button will discard changes. For the most part these settings can remain unchanged and all will
function as needed.
Figure 45 – Auto-Discovery Advanced Scan Settings Page
Sections/Fields Description
Min Refresh Interval
Minimum number of seconds required between fresh network scans. If
you attempt to scan the network more often than this you only get
results stored from a previous scan.
Maximum wait
Maximum number of seconds to wait for all packets to return.
Packet Count
Number of packets to send
TX Interval
Transmission interval between packets. Only meaningful when Packet
Count is greater than 1. Minimum allowed value is 0.2
Batch Size
Divide scanning range into batch jobs. Jobs are run sequentially. Each
job will have at most <Batch Size> pings running in parallel at a time.
The special value 255 means run all pings as one big job.
Network
Network address with last octet reserved for From and To range.
Example: 192.168.1.x
From
Start number for last octet of network address.
To
End number for last octet of network address.