IPitomy IP1100+ PBX Administrator Guide - Manual (Page 74)

IPitomy IP PBX Admin Guide
2011 Copyright  IPitomy Communication, LLC 56 v4.0.1
www.ipitomy.com
PIN
This is the number used to access the extensions voicemail and can be
between 1 and 6 digits long. The default setting is for the PIN to be the
extension number. Be sure to instruct users to change the PIN to avoid
unauthorized use.
Ring Time
This is the time in seconds that a call will ring before it is considered
unanswered. Ring time must be between 1 and 100 seconds in length.
Call Group
This number assigns this extension to a group with a similar purpose
(e.g., Sales or Customer Service). Multiple call groups can be assigned
to each extension by putting a comma between the group numbers.
The call groups also define which Pickup Groups can answer calls to
this extension.
Pickup Group
This number should match any Call Group number entered on an
extension. It defines the Call Group Numbers this extension can pickup
remotely by pressing 99.
Apply Schedule
When an extension is created, a schedule destination is created
automatically. This schedule is not activated until the Apply Schedule
box is selected. When it is selected, all calls sent directly to this
extension must first pass through the extension’s schedule and will be
routed accordingly. Extension schedules will appear with the name of
the extension (e.g., Extension 123 would appear as “ext_123”). (See
the Schedules section of this guide for more information.)
CID Override
If enabled, the user will be able to override the Caller ID settings. When
the user places a call, the original assigned CID will be bypassed and
the name and number will that is entered in the CID Name and Number
fields will be sent instead. Always check with your provider that CID
override is allowed before configuring.
CID Name
If the CID Override parameter is enabled, this is the Caller ID name
that will be seen by the recipient when an outbound call is placed.
Always check with your provider that CID override is allowed before
configuring.
CID Number
If the CID Override parameter is enabled, this is the Caller ID number
that will be seen by the recipient when an outbound call is placed.
Always check with your provider that CID override is allowed before
configuring.
Detect Fax
If checked, calls from an Analog or T1/PRI card that route direct to this
extension will spend a period of time (Defined under PBX
Setup
General) checking if the call is a fax. During this time, the PBX
holds the call; if fax tone is detected, the call will be passed along to
the destination defined for Route Fax To, otherwise it will pass the call
to the extension after the detection time has expired.
Route Fax To
Define where calls will be routed if fax tone is detected.
Table 17 – General Extension Settings and Descriptions