IPitomy IP1100+ PBX Administrator Guide - Manual (Page 55)

IPitomy IP PBX Admin Guide
2011 Copyright  IPitomy Communication, LLC 37 v4.0.1
www.ipitomy.com
Echo Cancellation
This allows you to configure the Echo Cancel parameter. By default this is set to Yes
(128) which will work in most scenarios. Adjustments can be made as needed.
RX Gain
This allows you to set or adjust the gain on sound received from these
lines/channels. Typically these settings don’t need to be changed from default
settings, unless there are issues relating to the volume on the calls. (This setting is
in decibels so 3.0 = 100% increases in volume). Default this is set to 0.0.
TX Gain
This allows you to set or adjust the gain on sound transmitted to these
lines/channels. Typically these settings don’t need to be changed from default
settings, unless there are issues with the volume on the calls. (This setting is in
decibles so 3.0 = 100% increases in volume). Default this is set to 0.0.
Inbound Caller ID
This is the name of the Caller ID of the inbound calls on this trunk. If set to the
system default “asreceived', the calls will capture the Caller ID information sent over
the incoming lines. Otherwise you can override the name and number that appears
to those receiving calls on the corresponding channels.
!
IMPORTANT: If you need to change this parameter, we
recommend that you contact IPitomy’s Technical Support
Group at (941) 306-2200 for the proper syntax or additional
information.
Echo Cancellation
Bridged
This allows you to enable or disable the Echo Cancellation Bridge parameter on
calls routed internally across the network. Set this parameter to”YES” (enable) if you
want echo cancellation on calls that are bridged from one port to another on the
network. Default this is set to No.
Busy Detect
By default, this is set to YES and 8. This allows you to enable/disable and set the
number of busy signals the system will detect before disconnecting from the call
(hanging up). Set the parameter to “YES” if you want the PBX to hang up after it
detects a busy signal.
The number field is the number of busy tones the system must detect before it
disconnects from the call (hangs up).
Outbound Caller ID
Name
Any values entered here will display as the Outbound CID Name when making calls
out this trunk. If this is left blank, the name displayed on outbound calls will match
what is registered with the provider. Blank by default.
!
IMPORTANT: Contact your provider to determine whether
CID override is allowed on your specific trunk
Outbound Caller ID
Number
Any numbers entered here will display as the Outbound CID number when making
calls out this trunk. If this is left blank, the number displayed on outbound calls will
match what is registered with the provider. Blank by default.
!
IMPORTANT: Contact your provider to determine whether
CID override is allowed on your specific trunk
Echo Training
This parameter is used to adjust the time spent training the echo cancellation
algorithm before a call is picked up. The length of time is set in milliseconds (ms),
and is set to 800 by default.
Route Calls to
This is the default destination for the trunk. A destination is where calls from this
provider will be routed to, unless a specific Direct Inward Dial (DID) is indicated. A
typical destination is defined as a Menu, Extension, Schedule, Voicemail, or a Ring
Group. This can also be set under the Incoming Routing page.
Relax DTMF This allows you to turn On/Off the Relax DTMF detection. Enabling this setting