IPitomy IP1100+ PBX Administrator Guide - Manual (Page 173)

IPitomy IP PBX Admin Guide
2011 Copyright  IPitomy Communication, LLC 155 v4.0.1
www.ipitomy.com
Security Settings Section
Log Watch/Ban Service
This feature allows the PBX to monitor the SIP registration traffic and ban any IP address that makes 5 failed
registration attempts. The IP address will be banned for either 5 days or until the service is restarted.
Configuration settings allow you to ignore (not monitor) IP addresses that are communicating from the LocalNet,
as well as allowing you to manually add addresses you want the system to ignore.
Figure 83 – PBX Security Log Watch and Ban Service Status
Enable Log Watch/Ban Service
STEPS:
1 From the PBX Setup General System Setup page, locate the Security Settings
section.
2 Enable the Log Watch Ban Service by setting the parameter to “Yes” on the drop-
down list.
3 Click the button to save the changes.
4 Scroll back to the Log Watch Ban Service panel and click the Reload button.
Set Log Watch/Ban Service Parameters
Once you have enabled the Log Watch/Ban Services, you will be able to configure the parameters for the security
settings.
Figure 84 – Security Log Watch and Ban Security Settings