IPitomy IP1100+ PBX Administrator Guide - Manual (Page 174)

IPitomy IP PBX Admin Guide
2011 Copyright  IPitomy Communication, LLC 156 v4.0.1
www.ipitomy.com
The following table describes the parameters and descriptions (recommended settings) for the Log Watch
and Ban feature.
Sections/Fields Description
Service is currently
Running This indicates the status of the service, either Running or Not Running.
Reload Button
Restarts the Ban service, clearing any existing banned IP addresses.
Enable Log Watch &
Ban Service
Set to Yes and the PBX will monitor failed SIP registration attempts. 5 failed
attempts and the IP is blocked for:
• 5days
• Until system reboot
• Until Reload button is clicked
Ignore IPs in SIP
LocalNets
Set to Yes and the PBX will ignore failed SIP registration attempts from IPs
from the LocalNets configured in the system. When set to No, IP addresses
from the LocalNets are ignored for failed attempts.
Ignoring Addresses
Lists the addresses that were manually entered to be ignored in regards to
failed SIP registration attempts
Add Entry
Enter the IP addresses you wish to be ignored by the PBX in regards to
failed SIP registration attempts.
Table 58 – PBX Security Log Watch/Ban Settings and Descriptions
Configure Log Watch/Ban Service
STEPS:
1 Navigate to PBX Setup General.
2 Scroll down to the Security Settings panel, set the parameters based on your
general business requirements.
3 Click the button to save the changes.
4 Navigate to the PBX Setup General page. Locate the Admin Settings section
(located at the top of the page).
5 Enter an IP address for Admin Email Address field. Depending on whether you
have Unified Messaging configured, the PBX will send an email to this address any
time that it bans an IP address. See the Unified Messaging section of this guide for
details on how to configure this parameter.
6 Click the Apply Changes link located at the top right hand corner of the page, to
commit the changes to the database.