IPitomy IP1100+ PBX Administrator Guide - Manual (Page 97)

IPitomy IP PBX Admin Guide
2011 Copyright  IPitomy Communication, LLC 79 v4.0.1
www.ipitomy.com
Factory Default Phone
STEPS:
1 From the Extensions Destinations page, click the Auto-Discovery Tab.
2 Click the “Auto-Discovery” button, choosing to scan or not scan the network as needed.
3 Click (placing a checkmark) on the boxes next to phones you wish to default.
4 From the Auto-Discovery page, click on the Command tab. Click the “Factory Default”
button. Wait long enough for the phones to default and restart. This could be anywhere
from 30 seconds to 2 minutes for each phone, depending on the model. The phones will
set themselves back to factory default and reboot during this period.
Troubleshooting Network Scanning Problems
Scan settings have been configured to work in a standard one subnet network environment. More
complicated environments may require further tuning. The most useful setting is ‘Maximum wait’.
However noisy environments will require increasing the packet Count and TX interval.
STEPS:
To tune scanning for your network:
1 From the Extensions Destination Auto-Discovery page, click on Advanced Scan
Settings link.
2 Increase the ‘Maximum Wait’ setting by a few seconds.
3 Click the GUI ‘Refresh’ button.
More specific tuning will require knowledge of your network and diagnostic tools like
Ping.
Phones that are in the process of restarting, turned-off, or operating on a different
network during a network scan will not be in an “Online” status.