IPitomy IP1100+ PBX Administrator Guide User Manual
Page 251
IPitomy IP PBX Admin Guide
Loading the Firmware File
1. Log into the PBX and navigate to PBX Setup=>Services
2. Scroll down to the File System panel
3. Click Browse and find the current firmware file ipitomy_pbx_<build#>-uf.tgz
4. Click Load File to begin the upgrade process
5. Depending on your starting firmware version, one of two things will occur:
1. A dialog box will pop up announcing that the PBX will reboot, click OK and wait 5 minutes. After
the 5 minutes has passed, log out of the PBX, then log back into the PBX (you should see a
message when logging in that the Database does not match and will be converted)
2. A progress bar will appear while the PBX upgrades and reboots, after which you will be returned
to the login screen.
6. Log into the PBX and a message will display stating the Database version does not match. Click OK and
the DB will update.
7. Click Apply Changes
Restoring Backups (Does not need to be done if you want to use the same DB as was previously
running on the system)
1. Navigate to PBX Setup=>Database
2. Find the backup you wish to load and click the curved arrow to restore it as the active database.
3. Once the Database loads, Click Apply Changes.
3. Navigate to PBXSetup->Services and Click "Restart All Services"
For systems with Digium© Analog Cards/T1/PRI Cards or Xorcom© USB Devices
1. If your system has any of these products installed, navigate to Providers=>Hardware Providers