Lug kits – Rockwell Automation 1336F PLUS II User Manual - Firmware 1.xxx-6.xxx User Manual
Page 25
Installation/Wiring
2–15
Table 2.D
TB1 Specifications
1
Wire sizes given are maximum/minimum sizes that TB1 will accept - these are not recommendations.Use
Copper wire only. Wire gauge requirements and recommendations are based on 75 degree C. Do not
reduce wire gauge when using higher temperature wire.
2
Applies to 30 kW (40 HP) 200-240V, 45 & 56 kW (60 & 75 HP) 380-480V, 56 kW (75 HP) 500-600V
drives only.
3
These configurations of TB1 are stud type terminations and require the use of lug type connectors to
terminate field installed conductors. Lug kits are available for use with these configurations. Wire size
used is determined by selecting the proper lug based on the drive catalog number. Refer to
4
One TE terminal is present – Max./Min. Wire Size is the same as other terminals.
5
Two TE terminals are present – Max./Min. Wire Size is the same as the D Frame terminal block.
Lug Kits
D, E, F and G Frame drives have stud type terminals and/or bus bars/
bolts that require standard “crimp type” connectors for cable termina-
tion. Connectors such as T & B Color-Keyed
connectors (or equiva-
lent) are recommended. The following table shows the lug selection
for one possible cable choice. Connectors for each installation should
be chosen based on desired cable sizes, the application requirements
and all applicable national, state and local codes. See the minimum/
maximum values for wire size per
Drive Frame
Size
Max./Min. Wire Size
1
mm2 (AWG)
Maximum Torque
N-m (lb.-in.)
A1-A4 (page
)
5.3/0.8 (10/18)
1.81 (16)
B1 (page
)
8.4/0.8 (8/18)
1.81 (16)
B2 (page
)
13.3/0.5 (6/20)
1.70 (15)
C (page
26.7/0.8 (3/18)
5.65 (50)
D (page
3, 4
120.0/2.1 (4/0 /14)
67.4/2.1 (00/14)
2
6.00 (52)
6.00 (52)
E (page
3, 5
253.0/2.1 (500 MCM/14)
10.00 (87)
3
303.6/2.1 (600 MCM/14)
23.00 (200)
G (page
)
3
303.6/2.1 (600 MCM/14)
23.00 (200)