Rockwell Automation 1336F PLUS II User Manual - Firmware 1.xxx-6.xxx User Manual
Page 62
3–10
Human Interface Module
Search Mode
Press these keys . . .
while following these steps . . .
The HIM Display will show . . .
1. The Search Mode is not available with a Series A HIM below version
3.0.
This mode allows you to search through the parameter list and display
all parameters that are not at the factory default values.
A. From the Status Display, press Enter (or any key). “Choose Mode”
will be shown.
B. Press the Increment (or Decrement) key until “Search” is displayed.
C. Press Enter. The HIM will search through all parameters and display
any parameters that are not at their factory default values.
D. Press the Increment (or Decrement) key to scroll through the list.
Choose Mode
Display
Choose Mode
Search
or
or
Control Status Mode
Press these keys . . .
while following these steps . . .
The HIM Display will show . . .
Control Logic
1. The Control Status mode is not available with a Series A HIM below
version 3.0.
This mode allows the drive logic mask to be disabled, thus preventing
a Serial Fault when the HIM is removed while drive power is applied.
The logic mask can be disabled with Series A HIMs (versions below
3.0) by using [Logic Mask] as explained on
A. From the Status Display, press Enter (or any key). “Choose Mode”
will be shown.
B. Press the Increment (or Decrement) key until “Control Status” is
displayed. Press Enter.
C. Select “Control Logic” using the Increment/Decrement keys. Press
Enter.
D. Press the SELect key, then use the Increment (or Decrement) key
to select “Disabled” (or “Enable”).
E. Press Enter. The logic mask is now disabled (or enabled).
Choose Mode
Display
Choose Mode
Control Status
Control Status
Control Logic
Control Logic
Disabled
or
&
or
&
or
&