Rockwell Automation 1336F PLUS II User Manual - Firmware 1.xxx-6.xxx - Manual (Page 63)

Human Interface Module 3–11
Control Status Mode (continued)
Press these keys . . . while following these steps . . . The HIM Display will show . . .
Fault Queue/Clear Faults 2. This menu provides a means to view the fault queue and clear it when
desired.
A. From the Control Status menu, press the Increment (or Decrement)
key until “Fault Queue” is displayed.
B. Press Enter.
C. Press the Increment (or Decrement) key until “View Faults” is
displayed.
D. Press Enter. The fault queue will be displayed. “Trip” displayed with
a fault will indicate the fault that tripped the drive.
E. Use the Increment (or Decrement) key to scroll through the list.
F. To clear the fault queue, press ESCape. Then use the Increment/
Decrement keys to select “Clear Queue.” Press Enter. Please note
that “Clear Queue” will not clear active faults.
Control Status
Fault Queue
Fault Queue
View Faults
Serial Fault
F 10 Trip 1
Reprogram Fault
F 48 2
Fault Queue
Clear Queue
or
or
or
or &