Rockwell Automation 1336F PLUS II User Manual - Firmware 1.xxx-6.xxx - Manual (Page 33)

Installation/Wiring 2–23
TB1 F-G
R
(L1)
S
(L2)
T
(L3)
R
S
T
380-480V, 187-448 kW (250-600 HP) Terminal Designations
500-600V, 224-448 kW (300-600 HP) Terminal Designations
To Motor
Required
Input Fusing
1
AC Input Line
typical terminal layout
(located at top of drive)
typical terminal
(located at bottom of drive)
W
(M3)
U
(M1)
V
(M2)
G
Frame
380-480V, 187-336 kW (250-450 HP) Terminal Designations
500-600V, 261-336 kW (350-450 HP) Terminal Designations
To Motor
T-L3 R-L1 S-L2 W-M3 U-M1 PE V-M2
F
Frame
1 Required Branch
Circuit Disconnect
1 User supplied.
Input Fusing
(Supplied)
AC Input Line
1 Required Branch
Circuit Disconnect
DC –
Brake
DC +
Brake
1336F-BPR and CPR Drives are supplied with a separately
mounted, pre-wired DC Bus Inductor (see Appendix B). If the
cable length between the choke and drive is not sufficient, longer
cables (same size & type) can be used. Cable routing must also
be considered when mounting the choke.
to –DC Terminal
on Brake
Brake terminals are located on the
DC Bus Inductor behind the "U" terminal
(access from the right side of the chassis)
to +DC Terminal
on Brake
W
U
V