ADS Environmental Services FlowShark QR 775003 A2 - Manual (Page 77)

3-20 ADS FlowShark IS Manual
2. Secure the sensor cable to the ring. Refer to Securing the
Cables to the Ring
on page 3-21 for instructions on properly
securing the cable.
Note: If the installation includes a pressure depth sensor,
wait to secure the sensor cables until both sensors are
installed on the ring.
Mounting the Pressure Depth Sensor
Mount the pressure depth sensor to the ring in the following way:
1. Orient the ring so that the ultrasonic depth sensor is directly on
top. If an ultrasonic depth sensor is not in use, make sure the
spreader assembly is directly on top.
2. Use two 4-40 x 5/16-inch stainless steel screws (do not
substitute any other screws) to mount the pressure depth sensor
on the bottom inside of the ring with the pointed end of the
sensor facing upstream. Mount the pressure depth sensor about
2 inches to the left of the velocity sensor (when present).
Mounting the pressure depth sensor to the ring
3. Secure the sensor cable to the ring. Refer to Securing the
Cables to the Ring
on page 3-21 for instructions on properly
securing the cable.