Altera High-Speed Development Kit, Stratix GX Edition - Manual (Page 32)

4–4 Quartus II Version 3.0 Altera Corporation
User I/O High-Speed Development Kit, Stratix GX Edition User Guide
You are finished testing the Stratix GX device user I/O. Perform the
following steps to execute the test for the Stratix device user I/O.
13. Set all of the Stratix user dipswitches (D6) to 0.
14. Press S_CLR (S12) to reset the design. The S_CLR LED (D24)
illuminates and the 7-segment display (D8) shows 00.
15. Press the Stratix channel pushbutton switches, Stratix_PB_0 (S8) for
up and Stratix_PB_1 (S9) for down. The channel numbers on the 7-
segment display (D8) increment and decrement.
16. Press S12 once.
17. Press S8 three times. D8 displays 03.
18. Press S9 four times. D8 displays 99.
19. Press the Stratix volume pushbutton switches, Stratix_PB_2 (S10) for
up and Stratix_PB_3 (S7) for down. The number of illuminated
Stratix LEDs increment and decrement.
20. Press S12 once.
21. Press S10 six times. All of the LEDs illuminate.
22. Press S7 six times. All of the LEDs turn off.
23. Enter the binary number 15.
a. Set dipswitches 4-1 to 1.
b. Set dipswitch 8 to the up position and then to the down
position to enter the value. D8 displays the number 15.
24. Enter the binary number 127.
a. Set dipswitches 7-1 to 1.
b. Set dipswitch 8 to the up position and then to the down
position to enter the value. D8 displays the number 99.
You have finished the user I/O test.