Perform the production diagnostic tests, Required hardware & software, Set up the board – Altera High-Speed Development Kit, Stratix GX Edition User Manual
Page 45: Chapter 5. perform the production diagnostic tests
Altera Corporation
Quartus II Version 3.0
5–1
5. Perform the Production
Diagnostic Tests
Required
Hardware &
Software
The following list describes the hardware and software you need to run
the production diagnostic tests.
■
Windows-based PC
■
Quartus II software
■
Parallel port cable
■
Serial port cable
■
PMC card (part number 853-10010 PMC100TX)
■
10/100-Mbit Ethernet network-interface daughter board (part
number NIOS-EDKX)
■
Six to ten short (1-foot) SMA cables
■
High-Speed Development Kit, Stratix GX Edition
●
Stratix GX development board revision C
●
ATX power supply
●
ByteBlaster II cable
●
Programming files
●
Four long (3-foot) SMA cables
●
HM-Zd loopback cards
●
SFP loopback card
●
Micron DDR DIMM
●
Compact flash card
Set Up the Board
The following procedure describes how to set up the board, including
attaching the daughter cards and cables.
1.
Install the PMC card on the back side of the board as shown in
Figure 5–1.