Stratix gx hm- zd spi-4.2 loopback, Required hardware, Test setup – Altera High-Speed Development Kit, Stratix GX Edition User Manual
Page 36: Stratix gx hm-zd spi-4.2 loopback –8, Stratix gx hm-zd spi-4.2 loopback
4–8
Quartus II Version 3.0
Altera Corporation
Stratix GX HM-Zd SPI-4.2 Loopback
High-Speed Development Kit, Stratix GX Edition User Guide
8.
The test continues until you press the Ctrl + C keys. Press these keys
to stop the status display in the SOPC Builder SDK Shell.
9.
Press S2 to stop the test.
Stratix GX HM-
Zd SPI-4.2
Loopback
The Stratix GX HM-Zd SPI-4.2 loopback test design tests the SPI-4.2
source synchronous signals at up to 1 Gbps using the provided HM-ZD
SPI-4.2 loopback cards.
Required Hardware
This test requires the following hardware:
■
HM-Zd SPI-4.2 loopback cards (labeled J108 and J109)
■
ATX power supply
Test Setup
Perform the following steps to set up the test.
1.
Remove power from the board.
2.
Install the HM-Zd SPI-4.2 loopback cards as shown in Figure 4–5.
3.
Set the board’s switches as shown in Table 4–1 for this test.