Altera High-Speed Development Kit, Stratix GX Edition User Manual
Page 46
Advertising
5–2
Quartus II Version 3.0
Altera Corporation
Set Up the Board
High-Speed Development Kit, Stratix GX Edition User Guide
Figure 5–1. Attach the PMC Card
2.
Attach the HM-Zd SPI-4.2 loopback card (labeled J108 on the card)
to the connector at J108, which is located on the bottom edge of the
board as shown in Figure 5–2.
3.
If your version of the Stratix GX development board has an
EP1SGX40GF1020C5 device, you may also need to attach a second
HM-Zd loopback card (labeled J109 on the card) to the connector at
J109 for the optional differential status signals.
Figure 5–2. Attach the HM-Zd Loopback Card
Advertising