Altera High-Speed Development Kit, Stratix GX Edition User Manual
Page 70
5–26
Quartus II Version 3.0
Altera Corporation
Nios-Based Tests
High-Speed Development Kit, Stratix GX Edition User Guide
9.
Confirm that you are connected to the Nios processor running on
the board by pressing the Enter key a few times in the terminal
window to display the processor’s memory contents.
10. Exit the terminal window by pressing the Ctrl + C keys.
11. Start the Ethernet test by typing
nr et.srec
r. This command
initializes the on-board MAC/PHY chip. Observe the shell for the
proper response. See Figure 5–21.
Figure 5–21. Ethernet Test Results
###################################
NOTE: w/ethernet cable plugged in (below)
[SOPC Builder]$ nr hello_plugs.srec
nios-run: Ready to download hello_plugs.srec over COM1: at 115200 bps
nios-run: Downloading...........................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
...
nios-run: Terminal mode (Control-C exits)
-----------------------------------------
Reinitializing...
[lan91c111] nr_lan91c111_reset: chip id = SMC91C11xFD
[lan91c111] r_lan91c111_detect_phy: found lan83C183 (lan91C111 internal)
[lan91c111] r_lan91c111_init_phy: 10bt
[lan91c111] r_lan91c111_init_phy: half duplex
[accepting offer] from server 137.57.185.13, for ip address 137.57.185.196, leas
e time 446301
[ ignoring offer] from server 137.57.185.13, for ip address 137.57.185.196, leas
e time 446301
[lan91c111] nr_lan91c111_reset: chip id = SMC91C11xFD
[lan91c111] r_lan91c111_detect_phy: found lan83C183 (lan91C111 internal)
[lan91c111] r_lan91c111_init_phy: 10bt
[lan91c111] r_lan91c111_init_phy: half duplex
[plugs] +-----------------------
[plugs] | initialized adapter lan91c111 at 0x00c204a0, 137.57.185.196
[lan91c111] nr_lan91c111_reset: chip id = SMC91C11xFD
[lan91c111] r_lan91c111_detect_phy: found lan83C183 (lan91C111 internal)
[lan91c111] r_lan91c111_init_phy: 10bt
[lan91c111] r_lan91c111_init_phy: half duplex