IDK MSD-54 Series Command Guide - Manual (Page 114)

MSD-54 Series Users Guide (Command Guide)
114
@ECV Edit video channel setting in cross point memory
Command
format @ECV, memory, v_1 (, v_2, v_3, v_4 )
Return value
format @ECV, memory, v_1 (, v_2, v_3, v_4 )
Parameter memory : Cross point memory
1 to 9
v_1-4 : Video output
-1 = Not control, 0 = OFF, 1 = IN1 to 9 = IN9
Example Send
Receive
@ECV,2,1,2,3,-1
@ECV,2,1,2,3,-1
If cross point memory 2 is loaded, OUT1 to 3
are set IN1 to 3, respectively, and OUT4 is not
controlled.
Related info. 8.13.3 Editing cross point
@GCV Get video channel setting in cross point memory
Command
format @GCV, memory
Return value
format @GCV, memory, video _1 (, video _2 , video _3, video _4) , name
Parameter memory : Cross point memory
1 to 9
video_1-4 : Video output
-1 = Not control, 0 = OFF, 1 = IN1 to 9 = IN9
Nothing is saved in the memory as factory default, the state is “-1” (Not controlled)..
If you save only audio (@SCA) at the first saving of cross point settings, “-1” (Not
control) is replied for unsaved video.
name : Memory name
Up to 10 characters using 20 to 7D. “2 ASCII codes”
Example Send
Receive
@GCV,2
@GCV,2,3,1,2,4
PATTERN2
Get video channel of cross point memory 2.
With the name, “PATTERN2”, the following settings
are saved: OUT1: IN3; OUT2: IN1; OUT3: IN2;
OUT4: IN4.
Related info. 8.13.3 Editing cross point
@RCA Load audio channel setting from cross point memory
Command
format @RCA, memory
Return value
format @RCA, memory
Parameter memory : Cross point memory
1 to 9
Example Send
Receive
@RCA,1
@RCA,1 Load audio channel of cross point memory 1.
Terminated normally.
Related info. 8.13.1 Loading cross point