IDK MSD-54 Series Command Guide - Manual (Page 80)

MSD-54 Series Users Guide (Command Guide)
80
@GSP Get speaker configuration
Command
format @GSP, ch
Return value
format @GSP, ch, number, speaker_1 (, speaker_2･･･)
Parameter ch : Input channel
1 = IN1 to 5 = IN5
number : Speakers
1 to 8 [Default]: 2
speaker_1-8 : Speakers to be used
0 = Front Left/Right [Default] 1 = Low Frequency Effect,
2 = Front Center, 3 = Rear Left/Right, 4 = Rear Center,
5 = Front Left/Right Center, 6 = Rear Left/Right Center,
7 = Front Left/Right Wide, 8 = Front Left/Right High,
9 = Top Center, 10 = Front Center High
Example Send
Receive
@GSP,1
@GSP,1,6,0,1,2,3
Get speakers of IN1
The following 6 speakers are used: Front
Left/Right, Low Frequency Effect, Front Center,
Rear Left/Right
Related info. 8.9.6 Speaker configuration
@RME Copy EDID
Command
format @RME, out, number (, name)
Return value
format @RME, out, number (, name)
Parameter out : Copy connector
1 = OUT1 to 4 = OUT4
number : number of the saved COPY DATA
1 to 8
name : Name of “COPY DATA”
Up to 10 characters using 20 to 7D. “2 ASCII codes”
The name of the “COPY DATA” can be pretermitted. If pretermitted, EDID setting is
saved without changing currently saved name.
Example Send
Receive
@RME,1,1
@RME,1,1
Copy the EDID data from the OUT1 monitor and
save to COPY DATA 1.
Terminated normally.
Send
Receive
@RME,3,4,800x600
@RME,3,4,800x600 Copy EDID data of the OUT3 monitor and
save to COPY DATA 4 named “800x600”.
Terminated normally.
Related info. 8.9.7 EDID Copy