IDK MSD-54 Series Command Guide - Manual (Page 60)

MSD-54 Series Users Guide (Command Guide)
60
@GFF Get video switching effect
Command
format @GFF
Return value
format @GFF, out_1 (, out_2, out_3, out_4 )
Parameter out_1-4 : Video switching effect of each output
[MSD-5401/MSD-5402/MSD-5403/MSD-5404]
0 = CUT, 1 = FADE OUT/IN,
2 = FREEZE + FADE OUT/IN [Default],
3 = LEFT→RIGHT WIPE, 4 = RIGHT→LEFT WIPE, 5 = TOP→BOTTOM
WIPE, 6 = BOTTOM→TOP WIPE
[MSD-5401SL/MSD-5402SL]
0 = CUT, 1 = DISSOLVE [Default],
2 = FREEZE+DISSOLVE, 3 = LEFT→RIGHT WIPE, 4 = RIGHT→LEFT
WIPE, 5 = TOP→BOTTOM WIPE, 6 = BOTTOM→TOP WIPE
Example Send
Receive
@GFF
@GFF,1,1,0,1
Get video switching effects when input channels are
switched.
Input channels are switched by:
OUT3: “CUT”; other outputs: “FADE OUT/IN” or
“DISSOLVE”.
Related info. 8.7.5 Video switching effects
@SFT Set video switching speed
Command
format @SFT, ch_1, time_1 (, ch_2, time_2･･･)
Return value
format @SFT, ch_1, time_1 (, ch_2, time_2･･･)
Parameter ch_1-4 : Output
0 = All outputs, 1 = OUT1 to 4 = OUT4
time_1-4 : Switching speed
100 = 0.1 seconds to 2000 = 2 Seconds [Default] 350 = 0.35 Seconds
Set the value by 10 ms. If you set a value other than 0 for the lower 1 digits, these
values will be rounded down. (For example, if you set it to 395, the speed is set to
390 ms.)
Example Send
Receive
@SFT,1,400
@SFT,1,400
Switching speed of OUT1 is 400 ms.
Terminated normally.
Related info. 8.7.6 Switching speed