IDK MSD-54 Series Command Guide User Manual
Page 85
MSD-54 Series Users Guide (Command Guide)
85
@SLF
Set LAN operation mode
Command
format
@SLF, connection, mode (, ip_1, ip_2, ip_3, ip_4, pjlink, tcp, password)
Return value
format
@SLF, connection, mode (, ip_1, ip_2, ip_3, ip_4, pjlink, tcp, password)
Parameter
connection
: Connection number
1 = Connection 1 to 8 = Connection 8
mode
: Operation mode
0 = RECEIVER mode [Default], 1 = TRANSMITTER mode
ip_1
: Upper bit of the destination IP address to ip_4 : Lower bit of the destination IP
address
0 to 255 = 8 bit (Decimal notation) [Default]: 192.168.001.200
Set this parameter only if you select TRANSMITTER mode above.
pjlink
: PJLink protocol connection
0 = PJLink not used [Default], 1 = PJLink used
Set this parameter only if you select TRANSMITTER mode above.
tcp
: Destination port number
1 to 65535 [Default]: 1100
Set this parameter only if you select TRANSMITTER mode and “0” (PJLink not used)
for pjlink above.
password
:
Up to 32 characters of the following ASCII codes: 30 to 39, 41 to 5A, 61 to 7A
(alphanumeric characters). “2ASCII codes”
Set this parameter only if you select TRANSMITTER mode and “1” (PJLink used) for
pjlink
above.
If you do not use password authentication to connect the device using PJLink
protocol, you can skip this parameter.
Example Send
Receive
@SLF,1,0
@SLF,1,0
Set operation mode of connection 1
to RECEIVER.
Terminated normally.
Send
Receive
@SLF,2,1,192,168,1,1,0,1300
@SLF,2,1,192,168,1,1,0,1300
Set connection 2 as follows:
Option mode: TRANSMITTER,
Destination IP address: 192.168.1.1,
PJLink: Not used, Destination port
number: 1300
Terminated normally.
Send
Receive
@SLF,3,1,192,168,1,2,1,PROJE
CTOR1
@SLF,3,1,192,168,1,2,1,PROJE
CTOR1
Set connection 3 as follows:
Operation mode: TRANSMITTER,
Destination IP address: 192.168.1.2,
PJLink: Used, Password:
PROJECTOR1
Terminated normally.
Send
Receive
@SLF,3,1,192,168,1,2,1
@SLF,3,1,192,168,1,2,1
Set connection 3 as follows:
Operation mode: TRANSMITTER,
Destination IP address: 192.168.1.2,
PJLink: Used, Password
authentication: Off
Terminated normally.
Related info.
8.11.4 Operation mode