IDK MSD-54 Series Command Guide - Manual (Page 99)

MSD-54 Series Users Guide (Command Guide)
99
@SEC Set control command (Control CEC)
Command format @SEC, no, delay, port, memo, error, ch_1, cec_1 (, ch_2, cec_2･･･)
Return value
format @SEC, no, delay, port, memo, error, ch_1, cec_1 (, ch_2, cec_2･･･)
Parameter no : Command number
1 to 32
delay : Delay time
0 to 999999
port : CEC control
This parameter is static 4096 if CEC control
memo:
Up to 14 characters of 20 to 7D except 2C (,). “2 ASCII codes”
. error : Processing if no reply from destination device
0 = Stop, 1 = Execute (Continue)
ch_1-4 : Output
1 = OUT1, 2 = OUT2, 3 = OUT3, 4 = OUT4
cec_1-4 : Control command
0 =Not controll, 1 = POWER OFF, 2 = POWER ON
If you send a parameter only to the outputs to be controlled, the outputs without
sent parameter are automatically set to “0” (Not controlled). Normally, you do not
need to send the parameter, “0” (Not controlled) for cec_1-4.
Example Send
Receive @SEC,7,0,4096,DISPLAY1
ON,0,1,2
@SEC,7,0,4096,DISPLAY1
ON,0,1,2
Register as follows to the control
command 7:
・
Delay: 0 ms
・ Memo: DISPLAY1 ON
・ Error: Stop
・ Turn on the device connected to
OUT1.
・
Not control all other outputs.
Related info. 8.12.1 Control commands