H3C Technologies H3C SecBlade NetStream Cards - Manual (Page 168)

153
Configuring IPv6 NetStream data export
To allow the NDE to export collected statistics to the NetStream server, configure the source interface out
of which the data is sent and the destination address to which the data is sent.
Configuring IPv6 NetStream traditional data export
Follow these steps to configure IPv6 NetStream traditional data export:
To do… Use the command… Remarks
Enter system view system-view —
Enter interface view
interface interface-type
interface-number
—
Enable IPv6 NetStream
ipv6 netstream { inbound |
outbound }
Required
Disabled by default.
This outbound keyword does not take effect
on SecBlade NetStream cards.
Exit to system view quit —
Configure the destination
address for the IPv6
NetStream traditional data
export
ipv6 netstream export host
ip-address udp-port
Required
By default, no destination address is
configured, in which case, the IPv6
NetStream traditional data is not exported.
Configure the source interface
for IPv6 NetStream traditional
data export ipv6 netstream export source
interface interface-type
interface-number
Optional
• By default, the interface where the
NetStream data is sent out (the interface
connects to the NetStream server) is used
as the source interface.
• H3C recommends you connect the
network management interface to the
NetStream server and configure it as the
source interface.
Limit the data export rate
ipv6 netstream export rate
rate Optional
No limit by default.
Configuring IPv6 NetStream aggregation data export
IPv6 NetStream aggregation is implemented by software for the product.
Follow these steps to configure IPv6 NetStream aggregation data export:
To do… Use the command… Remarks
Enter system view system-view —
Enter interface view
interface interface-type
interface-number
—